Buy this item and earn 449 points valued at $22.45.
The AVANTONE “Cabernet (C-series)” mics from AVANT ELECTRONICS are designed to offer true professional performance. They will meet or surpass the performance and specifications of much higher priced mics.
The AVANTONE CK-7 is truly a gorgeous looking and sounding microphone. The design, character and performance can be compared directly to some of the very finest FET mics…but at a fraction of their cost!
Our rugged CK-7 microphone body and capsule assembly are precision machined of BRASS.
Aesthetically, it features an elegant Metallic Cabernet Wine-Red finish, accented with polished nickel trim and grill.
The transformer coupled Discreet Class A FET circuitry will yield pleasing professional results comparable to much more expensive designs.
Any studio can proudly offer the CK-7 as a vocal mic or utility condenser due to its versatility…It exudes class visually as well as sonically.
Manufactured using the finest materials yielding a very solid feel, superb structural integrity and rugged reliability.
The versatile CK-7 mic is able to produce professional results with a warm, pleasing sonic character.
The included Custom Retro Shockmount is superb in allowing a precise positioning of the mic while inhibiting the transfer of unwanted vibrations up into the mic. This isolation allows for superior professional results.
3-Pattern CLASS A FET Microphone w/ dual 35mm gold sputtered thin Mylar capsules
-10 dB pad & 80 Hz LF roll off switches
Standard Included Items:
AVANTONE CK-7 Multi-Pattern FET Microphone
AVANTONE Custom Retro Shockmount
Elegant padded genuine wooden Mic box
Padded Aluminum storage / travel case
Studio vocals, acoustic guitar, mandolin, drum overheads, piano, room mic, etc…
The 3 patterns allow the CK-7 to be used in a variety of situations. The cardioid pattern is generally best used on vocals and single instruments. The omni mode works well in incorporating some room sound into the track. The figure 8 pattern allows 2 vocalists to use the mic at the same time from opposite sides.
The -10dB attenuation switch can be engaged when miking very high SPL sources to keep from overloading the electronics.
The 80Hz HIGH-PASS filter switch can be engaged to reduce rumble and to keep unwanted low frequencies from “muddying up” the track.
Type: True Condenser
Polar Pattern/s: Cardioid , Omni , Figure 8
Frequency Response: 20-20,000 Hz +/- 3dB
Output Impedance: <=250 Ohms
Maximum SPL : 139dB (0.5% THD @1000Hz)
S/N Ratio re 1Pa : 75dB
Output Connector: Male XLR 3 pin
High-Pass Switch 80 Hz 6dB/octave
Attenuation Switch -10 dB
Power Requirement: Standard 48 Volt Phantom
Included Accessories: Wooden Box & Shockmount, Metal Road case
Finish: Polished Nickel trim / Metallic Cabernet Red Body
Weight: .65 kgs / 1.4 lbs
Dimensions: 187mm x 51mm / 7.5" x 2"